Ten channel Timer

Digitally set timing circuits to produce ON and OFF timing periods.



    Two thumbwheel switches for each of the timing circuits (ON & OFF) can be changed by either turning the wheel at the bottom of the switch, or by using a screwdriver in the slot in the center of the switch. Both switches can be rotated from 0-9 in single digit steps. This gives a range of 00 to 99 in seconds or minutes, as selected by the two position switch located to the left of the ON switches (S5) and to the right of the OFF switches (S6). The timing is LINE SYNCHRONIZED and no calibration or alignment is necessary. With the OFF switches set to 00 the output will stay on.

(Option B) Settings of 01 to 99 multiplied by half the AC line frequency

Examples: 12 x 8.333 = 100msecs. and 60 x 8.333 = 500msecs



Back to Top